Customer Experiences

CSV125-3 Cycle Stop Valve
I love cycle stops knowledgeable customer service. They answer the phone and all of my repeated questions. I’ve run a cycle stop at home for almost 7 years without problem and loved the operation so much I’ve now added one to our campgrounds well house. (One more to go).

4.5 Gallon Pressure Tank, CSV125-3 Cycle Stop Valve
Great support from Sam with regards selecting the right equipment for the job. The result is a high quality lake irrigation system that exceeds my expectations in terms of quality and performance!

4.5 Gallon Pressure Tank, CSV125-3 Cycle Stop Valve
Great support from Sam with regards selecting the right equipment for the job. The result is a high quality lake irrigation system that exceeds my expectations in terms of quality and performance!

My well is located about 150’ from my house. The pressure tank is located in the house and the pump and pressure switch are in the well. I had terrible water hammering and the pump would cycle on/off rapidly when the faucets were turned off. The cycle stop valve absolutely, 100%, cured the issues, we have awesome pressure now and the pump works/cycles as it should.

Have a 19 liter pressure tank and a 1/2hp jet pump installed to boost water pressure. CSV really helped in maintaining the pressure and pump not cycling. Gives a bit of peace of mind when taking a shower and doing the laundry where both require large volume of water.

Have a 19 liter pressure tank and a 1/2hp jet pump installed to boost water pressure. CSV really helped in maintaining the pressure and pump not cycling. Gives a bit of peace of mind when taking a shower and doing the laundry where both require large volume of water.

I have a new home with a new irrigations system. The Irrigation system has 13 zone with 6 heads on each zone at a total of 18 gpm. I have a close friend that is in the irrigation business that told me that when I had a well drilled to have them install a Cycle Stop Valve. When I contracted with a well driller for a new well and I asked him about the Cycle Stop Valve he immediately went negative. So I just dropped it. We drilled to 410' and installed a 3hp pump putting out about 30gpm. After the well was installed and the irrigation system was on, the pump would cycle on and off about every 4 or 5 minutes. This would go on for 4½ hours every morning. Common sense told me this was going to cause premature failure of the submersible pump. So against my drillers advise, I installed the CSV125-3. Now the pump comes on at 40psi, pumps up to 50psi and stays there the entire time that the irrigation system is running. Once the irrigation system turns off, the pressure goes to 60psi and the pump shuts off. Everything works just like your website said it would. I am a very happy camper.
-
Product Reviews (9)
- pump
- cycle
- pressure
- irrigation
- valve
- installed
- job
- house
- water
- quality