PK125 Pside-Kick: Troubleshooting

Home » PK125 Pside-Kick: Troubleshooting

Symptom	Cause	Remedy
Pump is cycling off and on	Pressure switch not set correctly	Cut off pressure must be higher than CSV125 pressure. Increase pressure switch cut off or decrease CSV1A valve setting.
	Waterlogged pressure tank	Replace pressure tank
	Bad or torn diaphragm in CSV125	Replace valve
	Manifold not assembled correctly	Verify assembled as instructed
Low Pressure	Demand is more than pump can provide at current pressure setting	Reduce demand so it is within pump capabilities to maintain desired pressure.
Chattering	Too much air in tank	Reduce air pressure in tank to 5-7 PSI below pressure switch cut in pressure.
Chattering	CSV125 setting is too close to pressure switch cut off pressure	Set pressure switch cut off pressure at least 10 PSI higher than CSV125 setting.
Pump rapid cycles at start up and then begins to function correctly	Air pressure in tank too high	Reduce air pressure in tank to 5-7 psi below cut in pressure.
	Multiple check valves in system working against each other	Remove all but the check valve or foot valve on the pump itself.